0. Download and Install: Samsung USB Drivers 1.5.51.0 and ODIN
1. Just download the firmware version you want from this posts and extract the .tar or .tar.md5 file in the archive and save it somewhere.
2. Reboot your phone to download mode. To get download mode shut down the device. After it shuts off completely simultaneously press the Down volume key+ Home button + press the power button .
You should see a warning asking you to press volume up if you want to continue or volume down to cancel, press volume up. You are now in download mode!
3. Start Odin 3.**
- If your ROM is a single .tar.md5 package click on the AP/PDA button and browse to the .tar or .tar.md5 file that you extracted in step 1 and select it.
- If the package has more than one .tar archive then they will be labelled with PDA/Code, Phone/Modem and CSC. Just put them in the corresponding section of Odin like belowBL = Bootloader AP = PDA (CODE) CP = PHONE (MODEM) CSC = CSC
4. DO NOT PUT .PIT FILE AND DO NOT, I REPEAT, DO NOT TICK REPARTITION.
5. Connect the USB cable and wait for any required drivers to install and the ID:COM section to turn blue like below.
6. Click start to flash.
7. Do not disconnect the cable or turn off the device once the flash has started, it will reboot when it finishes.
*Note PDA/AP/CSC/CO/MODEM/etc
SM-J320H J320HXXU0APA8, SM-J320H J320HXXU0APB7, SM-J320H J320HXXU0APB8, SM-J320H J320HXXU0APBB , SM-J320F J320FXXU0APA8, SM-J320F J320FXXU0APB3, SM-J320F J320FXXU0APB7, SM-J320F J320FXXU0APB8
Samsung Galaxy J3 Firmware
Device Model : SM-J320F
Press Ctrl+F key and Write your Country or Region for searching.
|
0 Comments